NYFORS AutoCleaver S1
Description
The AutoCleaver S1™ senses the edge of the coating to automatically adjust the bare fiber length after cleaving. This feature is valuable when a specific and accurate bare fiber length is required. The requested bare fiber length is specified by the customer at order and can be fine tuned by software between 0 and 500 μm.
The cleaver is available for 80 and 125 μm fibers. The end face quality is excellent. Cleave angles are typically less than 0.3 degrees. The standard deviation of the bare length is +/- 0.01* for a 125/250 μm fiber and +/- 0.06* for a 80/170 μm fiber. In both cases the bare fiber length was 3.4 mm.
A built-in microprocessor controls all parameters and settings such as fiber positioning, clamping, fiber tension and the exact position and speed of the diamond blade. The result is a perfect cleave every time.
The cleaver can be connected to a PC that gives access to all programmable parameters and settings.
The AutoCleaver S1™ comes in a small bench top design.
For pricing, technical or any other questions please contact the supplier
- No registration required
- No markups, no fees
- Direct contact with supplier
Contact Supplier
How to order?
-
Ships from:
Germany
-
Sold by:
-
On FindLight:
External Vendor
Claim 3-Edge Page to edit and add data
Frequently Asked Questions
Yes, the cleaver can be connected to a PC that gives access to all programmable parameters and settings.
The AutoCleaver S1™ is an ultra high precision cleaver designed for production applications where close control of bare fiber length after cleaving is required.
The cleave angles are typically less than 0.3 degrees.
The power supply is external 12 V DC, 15 W.
The standard deviation of the bare length is +/- 0.01* for a 125/250 μm fiber and +/- 0.06* for a 80/170 μm fiber.